MIL-S-851D
3.6 Sizing.
3.6.1 Grit, Types I and II. The individual sizes of grit shall conform to the requirements in
Table II.
3.6.2 Shot, Types I and II. The individual sizes of shot shall conform to the requirements in
Table III.
3.6.3 Cut steel wire shot, Type III. the individual sizes of cut steel wire shot, as cut, shall be single-size, cylindrical cuttings and conform to the requirements of Table IV. This includes either the length of ten pieces found in column three, or, as an alternate, the weight of fifty pieces found in column four. When conditioned into ball form shapes, column four requirements only shall apply.
3.7 Reclaimed materials. the grit and shot shall contain reclaimed materials to the maximum extent possible without jeopardizing the material quality or performance of the equipment. The reclaimed material shall be reprocessed, remanufactured, or recycled in a manner which restores them to the same chemical composition and physical properties as the material originally selected for use on the bit assemblies. Reclaimed materials shall in inclusive of all alloying elements applicable that have been collected from discarded solid, liquid, or gaseous waste from garbage, refuse, sludge, and from other collections of materials.
3.8 Workmanship. The grit and shot shall be free from defective and foreign material which will affect the serviceability. It shall be manufactured in accordance with high grade commercial practice.
4. QUALITY ASSURANCE PROVISIONS.
4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the supplier is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified, the supplier may utilize his own facilities or any commercial laboratory acceptable to the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business